This is weird .. I am not able to get X to display over the tv. Yet, when I set xorg.conf up to use my monitor and I play back a recording it outputs to the TV. I have PVR-350 .. for those out there that have a PVR-350 and are on version .17. Can you tell me what version of ivtv you are on? Below is what I have .. fyi, things were kosher on version .16 .. one question I have, why do I show version ivtv rc3f and yet rc3e is showing on dmesg?
Thanks Kernel = kernel-2.6.10-1.12_FC2 ivtv-kmdl-2.6.10-1.12_FC2-0.2.0-64_rc3f.rhfc2.at ivtv-firmware-enc-2.04.024-4.at ivtv-0.2.0-64_rc3f.rhfc2.at ivtv-firmware-1.8a-4.at ivtvdev-0.8-1.rhfc2.at perl-Video-ivtv-0.13-6.rhfc2.at ivtv-firmware-dec-2.02.023-4.at dmesg output ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.2.0 (rc3e) loading ivtv: Linux version: 2.6.10-1.12_FC2 686 REGPARM 4KSTACKS gcc-3.3 ivtv: In case of problems please include the debug info ivtv: between the START INIT IVTV and END INIT IVTV lines when ivtv: mailing the ivtv-devel mailinglist. ivtv: Autodetected WinTV PVR 350 card ivtv: Found an iTVC15 based chip ACPI: PCI Interrupt Link [LNK3] enabled at IRQ 5 ACPI: PCI interrupt 0000:01:0a.0[A] -> GSI 5 (level, low) -> IRQ 5 ivtv: Unreasonably low latency timer, setting to 64 (was 32) ivtv: XXX PCI device: 0x01e0 vendor: 0x10de msp34xx: init: chip=MSP3448W-A2 +nicam +simple +simpler +radio mode=simple ivtv: i2c attach [client=MSP3448W-A2,ok] msp3410: daemon started msp3400: error while reading chip version tveeprom: Hauppauge: model = 48132, rev = J323, serial# = 7013124 tveeprom: tuner = Philips FM1236 (idx = 23, type = 2) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio_processor = MSP3440 (type = 11) ivtv: i2c attach [client=tveeprom[0],ok] ivtv: Tuner Type 2, Tuner formats 0x00001000, Radio: yes, Model 0x00a93493, Revision 0x00000001 ivtv: NTSC tuner detected ivtv: Radio detected tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 ivtv: i2c attach [client=(tuner unset),ok] saa7115: starting probe for adapter ivtv i2c driver #0 (0x10005) saa7115: detecting saa7115 client on address 0x42 saa7115: writing init values ivtv: i2c attach [client=saa7115[0],ok] saa7115: status: (1E) 0x01, (1F) 0xc0 saa7127: video encoder driver version V 0.3 loaded saa7127: Selecting NTSC video Standard saa7127: Selecting S-Video+Composite saa7127: Turn WSS off saa7127: Widescreen Mode 4:3 Full Format saa7127: Selecting Normal Encoder Input saa7127: Enable Video Output ivtv: i2c attach [client=saa7127[0],ok] ivtv: Encoder revision: 0x02040024 ivtv: Encoder Firmware is buggy, use version 0x02040011 ivtv: Decoder revision: 0x02020023 ivtv: Configuring WinTV PVR 350 card with 9 streams ivtv: Create DMA stream 0 using 256 16384 byte buffers 4194304 kbytes total ivtv: Registered v4l2 device, streamtype 0 minor 0 ivtv: Create DMA stream 1 ivtv: Registered v4l2 device, streamtype 1 minor 32 ivtv: Create stream 2 using 40 52224 byte buffers 2097152 kbytes total ivtv: Registered v4l2 device, streamtype 2 minor 224 ivtv: Create DMA stream 3 using 455 4608 byte buffers 2097152 kbytes total ivtv: Registered v4l2 device, streamtype 3 minor 24 ivtv: Create stream 4 ivtv: Registered v4l2 device, streamtype 4 minor 64 ivtv: Create DMA stream 5 using 16 65536 byte buffers 1048576 kbytes total ivtv: Registered v4l2 device, streamtype 5 minor 16 ivtv: Create stream 6 using 1024 2048 byte buffers 262144 kbytes total ivtv: Registered v4l2 device, streamtype 6 minor 228 ivtv: Create stream 7 ivtv: Registered v4l2 device, streamtype 7 minor 232 ivtv: Create DMA stream 8 ivtv: Registered v4l2 device, streamtype 8 minor 48 ivtv: Setting Tuner 2 tuner: type set to 2 (Philips NTSC (FI1236,FM1236 and compatibles)) by ivtv i2c driver #0 ivtv: Setting audio matrix to input 3, output 1 ivtv: Switching standard to NTSC. saa7115: decoder set norm NTSC saa7115: set audio: 0x01 saa7127: Setting Encoder Video Standard saa7127: Set NTSC Video Mode saa7127: Selecting NTSC video Standard ivtv: ivtv_enc_thread: pid = 3314, itv = 0xcead7420 ivtv: ivtv_dec_thread: pid = 3315, itv = 0xcead7420 ivtv: Initialized WinTV PVR 350, card #0 ivtv: ==================== END INIT IVTV ==================== ivtv-osd: Framebuffer module loaded (attached to ivtv card id 0) ivtv-osd: Framebuffer is at decoder-relative address 0x00510000 and has 1704960 bytes. ivtv-osd: screen coords: [0 0] -> [720 480] ivtv-osd: original global alpha = 208 ivtv-osd: current OSD state = 39 ivtv-osd: new global alpha = 208 (1 255 0) ivtv-osd: framebuffer at 0xd5510000, mapped to 0xcf910000, size 1350k ivtv-osd: mode is 720x480x32, linelength=2880 Console: switching to colour frame buffer device 90x30 ivtv-osd: fb0: iTVC15 TV out frame buffer device _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
