On 5/1/05, Nathan Lutchansky <[EMAIL PROTECTED]> wrote: > On Sun, May 01, 2005 at 04:26:24PM +0100, Peter Pauwels wrote: > > kernel: usb 3-1: new high speed USB device using ehci_hcd and address 5 > > usb.agent[4333]: wis-ezusb: loaded successfully > > /etc/hotplug/usb/wis-ezusb: load > > /usr/lib/hotplug/firmware/ezusb/hpi_PX-TV402U.hex for 93b/a004/1 > > to /proc/bus/usb/003/005 > > kernel: usb 3-1: USB disconnect, address 5 > > kernel: usb 3-1: new high speed USB device using ehci_hcd and address 6 > [reformatted for clarity] > > This is how the device gets initialized; when first connected, a new > firmware is pushed into the USB controller, which then disconnects from > the bus and reconnects with a new USB ID. So at least the hotplug scripts > are installed correctly. > > Following this you should see a message like "go7007: registering new > Plextor PX-TV402U-NA" or something. Since you're not, it looks like the > modules are installed incorrectly. Try running "modprobe go7007-usb" to > load the modules manually. -Nathan > > > _______________________________________________ > mythtv-users mailing list > [email protected] > http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users > > > >
On my Ubuntu system, the go7007 firmware (the second firmware loaded) doesn't load before the go7007-usb module, the fix for that was to modprobe -r go7007-usb after the firmware got loaded, and then modprobe go7007-usb to load the module again, and everything works. _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
