On Sat, 14 May 2005 12:37:42 -0700 (PDT) Howard Cokl <[EMAIL PROTECTED]> wrote:
> Then in mythtv-setup I assigned > the OTA lineup to the HD3K and then went into channel > editor and had it scan for channels. I get basic cable and up to now I was hooking it up to the 3 pvr-250s I have. When I installed the hd3000, I used the same cable as the now- replaced pvr-250. I tried to do the channel scanning but kept getting "Can't tune... Timeout" error message. But that could be because there is no acceptable signal coming on that cable. > Later after > running mythfilldatabase I edited the OTA channels and > added the xmlid to the scanned channels and marked the > zap2it channels invisible. Where can I find the xmlid's? I tried looking on the zap2it site and could not find them... -- Mitko Haralanov voidtrance at comcast dot net http://voidtrance.home.comcast.net ==========================================
_______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
