Johan Reinalda schrieb:
All,
I have just built a new box, based on FC3-x86_64, installed as plain
x86_64 without the 32-bit comp. libraries. (on Athlon64 2800+, ECS
755-A2 mobo, 512mb, 200gb, pvr-150mce, nvidia fx5200-svid)
Installed lirc 0.7.1 as usual, then installed 0.18.1-x86_64 from the
at repo (manually downloading rpms, as yum had some dependency
problems with myth-plugins).
myth runs fine, with one exception: I cannot get lirc support to work.
Using a home brew serial port receiver, the lirc setup shows working
when testing with 'mode2' (i see pulses), and with 'irw' (I see the
correct buttom definitions, both as root or as mythtv user). However,
Myth does not recognize/use lirc...
I have the same setup on a development box, running an older&slower
original athlon 32bit cpu, and also 0.18.1 (upgraded from the original
0.17 install) There things work. I pulled in the following two lirc
config files from this dev system which work there:
/etc/lircd.conf
~mythtv/.myth/lirrc
One difference I notice is the lack of following type entries in
/var/log/message (this does show up for irw, not when starting
mythfrontend) :
May 22 10:41:06 mythtv lircd-0.7.1[3584]: accepted new client on
/dev/lircd
What am I missing, or is it just that the x86_64 build does not
support lirc?
TIA,
Johan
_______________________________________________
mythtv-users mailing list
[email protected]
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
Did you ran irxevent (as the same user as mythfrontend) before you start
up your mythfrontend? It's important.!
Did you try to generate an symbolic link from ~mythtv/.lircrc to
~mythtv/.myth/lirrc ?
Greez
Oliver
_______________________________________________
mythtv-users mailing list
[email protected]
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
