I've followed Jarod's guide pretty much word-for-word for setting up Myth on FC3 and have run into a few issues. I'm using 2 PVR-150s and a GeForce FX 5200.
First, all I get is static when I set up Myth and enter Watch TV mode. I've set up my 150s in Myth's Capture Devices section as the 250/350 setting, which I'm presuming is correct. The system is recognizing at least 2 cards (/dev/video0 and /video1), and all I get is static on the screen, along with the on-screen programming information. I've even tried the following settings, and now I get static for one second, and then Myth locks up and gives me an error. Maybe this is because I'm still using the monitor instead of the TV right now... # /usr/bin/ivtvctl -u 0x3000 # /usr/bin/ivtvctl -p 4 (I've tried 0 and 1 also) # /usr/bin/ivtvctl -f width=720,height=480 Any ideas from anyone that might know my problem or something good to try would be greatly appreciated, especially since I'm sure someone else out there is running 150s successfully =). Finally, on the annoying side, the /dev/video0 and /dev/video1 devices aren't showing up in the system until I run the "/sbin/modprobe ivtv" command as root. Where can I put this command so it will run as root on startup? Again, any suggestions are greatly appreciated. Thanks!!! Jason _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
