Scott,
You might have to recompile the 6200ch.c binary and hardcode the
"node" to 2, that's what I had to do to get my DCT6200 to work on my
KnoppMyth system.
There's a firewire/1394 app called gscanbus
(http://www.linux1394.org/start_test.php) that you can run in X to
determine the node of your DCT6400 (I had trouble figuring out how to
interpret the gscanbus reports...you may not, but good luck anyway!).
I took a look at 6200ch.c in a text editor, found the only reference to
"node", changed it from "0" to "2", saved it, re-compiled 6200ch.c and
it worked. (I think, it's been awhile since I did this and I stupidly
didn't take notes).
That should make things work for you, I'm pretty sure.
-Bob K.
Firewire Model: DCT-6200
Firewire Connection Type: Point to Point and Broadcast (I've tried
both)
Firewire Port: 0
Firewire Node: 1
Firewire Speed: 100Mbps
Default Input: MPEG2TS
_______________________________________________
mythtv-users mailing list
[email protected]
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
