> I finally was able to try the steps you outlined (above). > > When I got to step 6) - the Channel Editor, I didn't see > anything about a scan, Automatic or otherwise. > There weren't places to enter frequencies or > bandwidths either. > > Should I have run mythfilldatabase before trying the > Channel Editor? Another question: where inside the > Channel Editor does the Scan option appear? > > Maybe I haven't compiled mythtv with the right > set of options on the ./configure command. > I used ./configure --enable-dvb, and it seemed > to compile without any problems. > > Any further hints you might think of would be > most welcome.
Strange. When I go into the Channel Editor I see a screen which has a box at the top to list channels, then below that 2 drop down boxes called Sort Mode and Video Source, then a checkbox for Hide channels and then at the bottom of the screen 2 buttons - Scan for channels & Advanced. When you click that Scan for channels button that's when you get to enter the frequency. Could be a couple of reasons why you don't see these buttons: - Maybe they're hidden off the bottom of the screen? I don't know how you fix that but there will be lots in the archives about buttons not fitting onto the screen. - Maybe you have to enable something else when compiling MythTv? I install from ATRPM binaries so I don't know how that works. Good luck, Phill Regards, Phill _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
