On Sunday 12 June 2005 12:29, Johan Tufberg wrote: > No probs simon ;-).. What linux os are you running? Have you tried the > linuxtv package and compiled the drivers from their source?!
gentoo i have tried the dvb driver in the kernel source and the cvs from linuxtv > > Anyway, there have to be someone out there who have successfully > installed and setup diseqc switching (1.0, 2-way). I've read somewhere > on these lists that the problems with Diseqc was encountered with the > 0.17 release or I may be wrong in this case?! > > I've checked the ouput from mythtv-setup and when I'm using the first > LNB to scan the transponders I see this command is sent: > > "DiSEqC 1.0 Switch - Port 0 > DiSEqC Sending 1.0 Command: e0 10 38 f1" > > Shortly thereafter I get a lock on the signal. But when i use the second > videosource, the one that is connected to LNB2, i get the following > command: > > "DiSEqC 1.0 Switch - Port 1 > DiSEqC Sending 1.0 Command: e0 10 38 f4" > > and after this I get No Lock. So from this I see that the commands sent > to the switch may is only different by the last piece "f1" and "f4". Is > this correct?! I only have two LNB's. i have problems before i get to mythtv i cannot get scan to find channels on the second lnb well it does find channels but they are from the first lnb (like it didn; actually switch) -- Simon _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
