Tried that and got nowhere. Tried updating driver to 7664 and got nothing(was at 7174)
On 7/7/05, Fedor Pikus <[EMAIL PROTECTED]> wrote: > On 7/7/05, Justin Popa <[EMAIL PROTECTED]> wrote: > > Had a thread before about this, but I have hit a new problem now. I > > use FC3, with a GF4MX440. If I use the default config(xorg.conf.orig) > > that FC sets up for me(with driver nv changed to nvidia) X loads fine. > > If I then load my modified conf file over it(xorg.conf.new) and do an > > init 3/init 5.. everything works perfectly. Then, the next time I > > boot(using the new conf), I get zero on any display. I've attached the > > confs, and the X log. Thanks! > > Log is not complete, so it's hard to see what went wrong. After your last line > > (++) using VT number 7 > > normally you should see PCI scan lines. If you really don't have them, > then the driver is hung pretty badly. > > If it works with your original config (with "nvidia" driver), try to > isolate the problem: first, remove all twinview options. If it works, > try only these: > > Option "TwinView" > Option "SecondMonitorHorizSync" "30-50" > Option "SecondMonitorVertRefresh" "60" > Option "MetaModes" "800x600, 800x600; 640x480, 640x480" > Option "TwinViewOrientation" "Clone" > > (Note that your MetaModes line does not match your Modes line later in > the file, it does not > list all modes, I don't know if it matters). > -- > Fedor G Pikus ([EMAIL PROTECTED]) > http://www.pikus.net > http://wild-light.com > _______________________________________________ > mythtv-users mailing list > [email protected] > http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users > _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
