Hi, I use a PVR-500 (2x150). The two halves of the card are mapped to /dev/video0, and /dev/video1 respectively. Both tuners are set to tuner0.
If I use "Y" to cycle between cards, I get very long blanks, after which the card is either found or live tv aborts and brings me back to the mythfrontend main menu. When I start live tv, the screen is blank for a few seconds, then I get 1:tuner 0 with weird colours. An info box pops up saying: You should have gotten a channel lock by now..., The colours sometimes right themselves after some seconds, sometimes not. pressing "y" now gives me a break, then : 2:tuner 0 with good colours, but the info box pops up again. This is new and happened after my disk problems yesterday which resulted in a temporary failure to load the firmware. After an overnight shutdown the firmware loads ok. I am also not getting sound with card 1, but remember a thread on this so will look it up in the archives. Cheers Marius _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
