On 09/10/05, Chris Gackstatter <[EMAIL PROTECTED]> wrote: > > > > I am trying to determine if I have a faulty board or I just have a setting > that does not work. > > > > > > I am following wilsonet for FC4 instruction. This works great for me as I > have the identical hardware/software (FC4 and two captures cards PVR250 and > a PVR500) > > > > I recently installed the PVR500 following wilsonet and also found on the > mythtv user mail list the instruction on updating the firmware for the > PVR500. When I did this I had both tuners on the card working well using > the cat /dev/video1 > /tmp/test_capture.mpg suggested by willson. > Unfortunately in my haste to get the card working I screwed up something in > my mythsetup that caused my hard drive to be filled and I was only able to > access the system in fail safe mode. I corrected this problem by deleting > the MySQL database. > > > > > > Just to make sure everything was working correctly I reinstalled the > firmware for the PVR500 and ran the cat /dev/video1 > /tmp/test_capture.mpg > test again This time only one of the tuners (video2) worked, video1 just > gives a gray screen. > > > > I have checked and re-checked. All my setting re follows the recommendation > of wilsonet. Normally I would assume that I have a setting wrong, but being > I have seen these settings work before by backend crash I am beginning to > suspect a hardware problem. > > > > Does any one have any suggestions? >
Check http://ivtvdriver.org/index.php/Troubleshooting and http://ivtvdriver.org/index.php/Asking_for_help N. _______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
