I just finished an install from Jarod's instructions, PVR 250 silver & black, got the file or it from the lirc web site. They have hundred's of conf files for remotes there.
David On Wed, 2005-11-02 at 23:52 +0000, Nick wrote: > On 02/11/05, Marty Ravell <[EMAIL PROTECTED]> wrote: > > >On 01/11/05, Marty Ravell <[EMAIL PROTECTED]> wrote: > > >> I started messing with my lirc config in order to get my serial > > transmitter > > >> working and have somehow messed things up. Am wondering if these symptoms > > >> ring bells for anyone. > > >> > > >> If I use irrecord to build an lircd.conf file it seems to work. I can > > test > > >> it with irw and most buttons (not all) work. > > >> > > >> For some reason if I use the lircd.conf file suggested in Jarod's (most > > >> excellent) guide I get nothing. > > >> > > >> This same suggested lircd.conf used to work fine before I messed with > > >> things. > > >> > > >> I don't recall exactly what it was I did when I was trying to get the > > serial > > >> transmitter working. The box didn't start acting up until it was rebooted > > >> (much later). > > >> > > >> Any ideas where I start looking to track this down? > > >> > > >> I've had a couple of goes getting irrecord to build a new file which will > > >> work but it does not seem all that accurate. Some buttons just refuse to > > >> work (1, 5, etc) > > > > > >Do you have all of your remotes defined in the same /etc/lircd.conf > > >file? I have my actual remotes, and also the definition for my > > >transmitter in the same file. Did you generate the config for the > > >transmitter in normal or raw mode? > > > > > >Nick > > > > > > > I did have both the transmitter and receiver configs in the same lircd.conf > > file. Once it all went pear shaped however I reverted back to the lircd.conf > > file specified in Jarod's guide so I could see if I could get the standard > > PVR-350 remote working again. > > > > To date I have had little joy in getting this basic config back up and > > working. > > > > I know that the hardware is basically working since I can use irrecord to > > generate a new lircd.conf for the Hauppauge remote. It works for about two > > thirds of the buttons (and I figure could maybe be made to work for the rest > > with some manual tweaking). > > Which Hauppauge remote do you have? Is it the newer all silver remote, > or the older one with a silver face and black underside? If you want > to post your lircd.conf, I can take a quick look when I have a minute. > I can't think of a reason why Jarod's file no longer works with it- > have you reinstalled LIRC at all, or just created new lircd.conf > files? > > Nick > _______________________________________________ > mythtv-users mailing list > [email protected] > http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
_______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
