I cut this down to make it to the list. Thanks
On 11/19/05, *Don Sheehan* <[EMAIL PROTECTED]
<mailto:[EMAIL PROTECTED]>> wrote:
I am having very little success setting up myth on multiple
levels. Any help is greatly appreciated. I am pulling my hair
outand there was not much to start with!
At this point, after following more than a few howto's and
guides, I am ready to start over if that is the best course of
action. Is there a clean howto for gentoo with TV-out working?
Thanks!
Gentoo 2.6.14
ATI Radeon 7000
Hauppauge 150MCE w/ remote
media-tv/mythtv-0.18.1-r1
media-tv/ivtv-0.4.0-r2
app-misc/lirc-0.7.0-r1
I could not get TV-out to work with the radeon driver but it is
working with vesa
Is this a possible problem?
It was in color, now it is B&W only, ugghhh
I cannot get the video input to show anything but black static.
The cable (RG-6) is attached to the coax connector and I have
checked that there is signal.
Which device is the right one? I get output from
/dev/v4l/video0, video24 and video32 but it is black static.
I have followed the ivtv guidance to get the firmware into
/lib/modules... but no change even after a reboot.
The mce remote does not work. (it is the one with gray on top) I
tried jarod's file and the one that gets created by manually when
I compiled lirc from source.
The lircd log below shows it as ok after the last reboot and
it loads the firmware accorging to dmesg below.
irw show nothing.
Now I have lots of this in /var/log/messages and dmesg
Nov 19 20:16:28 gentoo ivtv0 warning: ENC Stream 0 OVERFLOW
#158240: Stealing a Buffer, 512 currently allocated
Linux version 2.6.13-gentoo-r5 ([EMAIL PROTECTED]) (gcc version 3.3.6
(Gentoo 3.3.6, ssp-3.3.6-1.0, pie-8.7.8)) #1 SMP Sat Nov 5
08:01:36 EST 2005
<snipped>
511MB LOWMEM available.
found SMP MP-table at 000ff780
On node 0 totalpages: 130864
DMA zone: 4096 pages, LIFO batch:1
Normal zone: 126768 pages, LIFO batch:31
HighMem zone: 0 pages, LIFO batch:1
DMI 2.3 present.
ACPI: RSDP (v000 ACPIAM ) @ 0x000faac0
<snipped>
vesafb: ATI Technologies Inc., R100, 01.00 (OEM: ATI RADEON VE)
vesafb: VBE version: 2.0
vesafb: protected mode interface info at c000:5478
vesafb: pmi: set display start = c00c550c, set palette = c00c5558
vesafb: pmi: ports = a010 a016 a054 a038 a03c a05c a000 a004 a0b0
a0b2 a0b4
vesafb: monitor limits: vf = 0 Hz, hf = 0 kHz, clk = 0 MHz
vesafb: scrolling: redraw
Console: switching to colour frame buffer device 80x30
vesafb: framebuffer at 0xe0000000, mapped to 0xe0880000, using
10240k, total 65536k
fb0: VESA VGA frame buffer device
<snipped>
Linux video capture interface: v1.00
ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.4.0 (tagged release) loading
ivtv: Linux version: 2.6.13-gentoo-r5 SMP preempt 586 4KSTACKS
gcc-3.3
ivtv: In case of problems please include the debug info
ivtv: between the START INIT IVTV and END INIT IVTV lines when
ivtv: mailing the ivtv-devel mailinglist.
ivtv0: Autodetected WinTV PVR 150 card (iTVC16 based)
ACPI: PCI Interrupt 0000:00:0d.0[A] -> GSI 18 (level, low) -> IRQ 17
ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50]
tveeprom: Hauppauge: model = 26582, rev = C299, serial# = 8441914
tveeprom: tuner = <unknown> (idx = 99, type = -1069535552)
tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000)
tveeprom: audio_processor = MSP3410D (type = 5)
: chip found @ 0xc2 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61]
cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0)
cx25840 0-0044: loaded /lib/modules/HcwMakoA.ROM firmware (14264
bytes)
ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44]
wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b]
ivtv0: loading /lib/modules/ivtv-fw-enc.bin
ivtv0: Encoder revision: 0x02050032
ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers
(4096KB total)
ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers
(2048KB total)
ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers
(2048KB total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers
(2048KB total)
ivtv0: Create encoder radio stream
tuner 0-0061: tuner type not set
tuner 0-0061: tuner type not set
ivtv0: Initialized WinTV PVR 150, card #0
ivtv: ==================== END INIT IVTV ====================
<snipped>
usb 2-2: new full speed USB device using uhci_hcd and address 2
usb 2-2: ep0 maxpacket = 16
usb 2-2: default language 0x0409
usb 2-2: new device strings: Mfr=1, Product=2, SerialNumber=3
usb 2-2: Product: eHome Infrared Transceiver
usb 2-2: Manufacturer: SMK
usb 2-2: SerialNumber: SM003w0J
usb 2-2: hotplug
usb 2-2: adding 2-2:1.0 (config #1, interface 0)
usb 2-2:1.0: hotplug
<snipped>
usb 2-2: new full speed USB device using uhci_hcd and address 3
usb 2-2: ep0 maxpacket = 16
usb 2-2: default language 0x0409
usb 2-2: new device strings: Mfr=1, Product=2, SerialNumber=3
usb 2-2: Product: eHome Infrared Transceiver
usb 2-2: Manufacturer: SMK
usb 2-2: SerialNumber: SM003w0J
usb 2-2: hotplug
usb 2-2: adding 2-2:1.0 (config #1, interface 0)
usb 2-2:1.0: hotplug
<snipped>
ALSA sound/pci/via82xx.c:580: codec_read: codec 0 is not valid
[0xfe0000]
ALSA sound/pci/via82xx.c:580: codec_read: codec 0 is not valid
[0xfe0000]
ALSA sound/pci/via82xx.c:580: codec_read: codec 0 is not valid
[0xfe0000]
ALSA sound/pci/via82xx.c:580: codec_read: codec 0 is not valid
[0xfe0000]
ACPI: PCI Interrupt 0000:01:00.0[A] -> GSI 16 (level, low) -> IRQ 21
radeonfb: cannot reserve FB region
<snipped>
gentoo ~ # more /var/log/lircd
Nov 18 20:31:15 gentoo lircd 0.7.1: lircd(mceusb) ready
Nov 18 20:31:22 gentoo lircd 0.7.1: accepted new client on /dev/lircd
Nov 18 20:31:22 gentoo lircd 0.7.1: could not get file
information for /dev/lirc0
Nov 18 20:31:22 gentoo lircd 0.7.1: default_init(): No such file
or directory
Nov 18 20:31:22 gentoo lircd 0.7.1: caught signal
Nov 18 18:53:15 gentoo lircd 0.7.1: lircd(mceusb) ready
Nov 19 18:56:22 gentoo lircd 0.7.1: accepted new client on /dev/lircd
Nov 19 18:56:22 gentoo lircd 0.7.1: could not get file
information for /dev/lirc0
Nov 19 18:56:22 gentoo lircd 0.7.1: default_init(): No such file
or directory
Nov 19 18:56:22 gentoo lircd 0.7.1: caught signal
Nov 18 20:34:09 gentoo lircd 0.7.1: lircd(mceusb) ready
gentoo ~ # irw
gentoo ~ #
mythfrontend starup messages
Total desktop width=640, height=480, numscreens=1
2005-11-19 21:03:27.058 Using screen 0, 640x480 at 0,0
2005-11-19 21:03:27.061 mythfrontend version: 0.18.1.20050510-1
www.mythtv.org <http://www.mythtv.org>
2005-11-19 21:03:27.061 Enabled verbose msgs : important general
2005-11-19 21:03:27.572 Switching to square mode (blue)
mythtv: could not connect to socket
mythtv: Connection refused
lirc_init failed for mythtv, see preceding messages
2005-11-19 21:03:27.846 Joystick disabled.
2005-11-19 21:03:27.915 Registering Internal as a media playback
plugin.
2005-11-19 21:03:28.210 Registering MythDVD DVD Media Handler as
a media handler
2005-11-19 21:03:28.211 Registering MythDVD VCD Media Handler as
a media handler
2005-11-19 21:03:28.980 Registering MythMusic Media Handler as a
media handler
[EMAIL PROTECTED] ~ $ lsmod
Module Size Used by
ipv6 250528 18
snd_pcm_oss 59392 0
snd_mixer_oss 19584 1 snd_pcm_oss
snd_seq_dummy 3684 0
snd_seq_oss 34368 0
snd_seq_midi_event 7008 1 snd_seq_oss
snd_seq 57040 5
snd_seq_dummy,snd_seq_oss,snd_seq_midi_event
ohci_hcd 34916 0
parport_pc 39716 0
parport 35880 1 parport_pc
floppy 59316 0
pcspkr 3616 0
rtc 9172 0
radeonfb 22804 0
snd_via82xx 28800 0
gameport 16264 1 snd_via82xx
snd_ac97_codec 79292 1 snd_via82xx
snd_pcm 97764 3
snd_pcm_oss,snd_via82xx,snd_ac97_codec
snd_timer 26660 2 snd_seq,snd_pcm
snd_page_alloc 10856 2 snd_via82xx,snd_pcm
snd_mpu401_uart 8096 1 snd_via82xx
snd_rawmidi 26720 1 snd_mpu401_uart
snd_seq_device 8652 4
snd_seq_dummy,snd_seq_oss,snd_seq,snd_rawmidi
snd 63524 13
snd_pcm_oss,snd_mixer_oss,snd_seq_dummy,snd_seq_oss,snd_seq_midi_event,snd_seq,snd_via82xx,snd_ac97_codec,snd_pcm,snd_timer,snd_mpu401_uart,snd_rawmidi,snd_seq_device
i2c_viapro 8176 0
ehci_hcd 47080 0
uhci_hcd 34348 0
sata_via 8516 0
tda9887 13264 0
wm8775 6204 0
cx25840 39732 0
firmware_class 10368 1 cx25840
tuner 35976 0
tveeprom 11792 0
ivtv 210836 0
i2c_algo_bit 9480 1 ivtv
i2c_core 21696 7
i2c_viapro,tda9887,wm8775,cx25840,tuner,tveeprom,i2c_algo_bit
videodev 9888 1 ivtv
sk98lin 164448 0
sata_promise 11012 0
libata 46532 2 sata_via,sata_promise
amd64_agp 12232 1
agpgart 35280 1 amd64_agp
usbcore 133308 4 ohci_hcd,ehci_hcd,uhci_hcd
dm_mod 58076 0
------------------------------------------------------------------------
_______________________________________________
mythtv-users mailing list
[email protected]
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
