No - I have the same setup. As long as the serviceid in the channels table is different for those channels it will pickup the right channel.
If you run mythbackend with -v all it shows you the available service id's when it tunes to a station. David -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Gary Manning Sent: Wednesday, November 23, 2005 4:22 PM To: 'Discussion about mythtv' Subject: RE: [mythtv-users] Fusion 5 Tuning problems On Tuesday 22 November 2005 09:16, David Ellis wrote: > First off go into "Advanced Options" on your capture card in MythTV > Setup, make sure your using TS Mode (not PS). > > Then, follow these steps: > > 1) Grab the frequency from you channels.conf (it will look like > 525000000). > > 2) Add a new row to your dtv_multiplex table with the correct > frequency, make sure the modulation is set to qam_256 > > 3) Set the dtv_multiplex field of your channel in the channel_id to > the id generated for you in 2. If you know the service id set it in > serviceid field of your channels table. > > 4) Set the initial channel to tune in card input to a valid channel > number - restart mythbackend. > > If you don't know the Service ID, run mythbackend with "-v all" and > one of the debug messages includes all the service id's myth see's on > the channel. > > David Right now I have 2-3 (sub)channels in the channels table pointing to one row (frequency) in the dtv_multiplex table, since they share the same frequency. Could this be the problem? Gary
_______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
