Re: [mythtv-users] How to stop changing channel on PVR-150 internal tuner?

Sat, 31 Dec 2005 18:22:15 -0800

Did you fill in the channel change command box in mythtv-setup? It's on the same screen that you set the default channel at. Also if you use two cable boxes you'll probably need to install a second serial port and get a second IR blaster. Unless the new cable box used different IR command codes but probably it will be the same model as the one you have.

On 12/31/05, obscure information. <[EMAIL PROTECTED]> wrote:
Hello again,

In addition to the lirc issue where MythTV is crashing, I have another issue... whenever I use the channel change on the remote, it changes the tuner's internal channel off of 3, which I have configured in mythtv-setup as the channel that cable box broadcasts on.  I only want the channel change command going to the IR-Blaster.

Also, yet another general question - I'm building my MythTV box around an older Dell OptiPlex that only has one serial port.  Seeing as how I am currently using said serial port for the IR-Blaster, what will I do when I get a second PVR-150 card and need an IR-Blaster for the second cable box?

Thanks again,

~Andrew

_______________________________________________
mythtv-users mailing list
[email protected]
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users





--
Joshua Frank
[EMAIL PROTECTED] 
_______________________________________________
mythtv-users mailing list
[email protected]
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users

Reply via email to