Mudit Wahal wrote:
>Its channel_subchannel if you are viewing OTA stuff.
>Instead of watching liveTV, try recording an OTA HD channel from the program.
>
>Also try this in mysql
>
>use mythconverg;
>update cardinput set startchan="2_1";
>(or whatever is your starting lineup in HD OTA list)
>
>
>
Also, make sure you have the hd-3000 setup as a dvb device and not a
hd-3000. If your channel scan doesn't go through and merge the channels
from the transports to the zap2it list. You'll have to manually set it
up in mysql.
Read the 4th post down
http://www.gossamer-threads.com/lists/mythtv/users/150073
I have HD video in Myth and it's sweet looking! Thanks to everyone. Although, of course...
I have no sound :( Do I have to run a cable from the back of the HD-3000 or is it embedded in the stream and something else is wrong? Sometimes it cackles when I switch channels, but other than that nothing. My PVR-250 and 500 both have audio going just fine though. Is there some special config I have to do to get the audio out from the board?
I am running audio out over SPDIF to an older SBLive - is it possible my sound card is too crappy? I see a lot of pre-buffering audio messages on the frontend.
Thanks again,
Chris
_______________________________________________ mythtv-users mailing list [email protected] http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
