Nice rig Jeff!!! John
From: [email protected] [mailto:[email protected]] On Behalf Of Jeff G Sent: Saturday, January 18, 2014 10:46 AM To: [email protected] Subject: [N8VEM-S100:2258] My recently completed S-100 test setup Hi All, Andrew has asked us to post picture of our progress and I promised to to so when I completed parts of my project. I attached an image of my recently completed S-100 test/development setup. I already have a few S-100 chassis so I wanted something that was lighter & a little more handy to store & work with. I decided to mount the parts on 3/4" plywood. I used a Meanwell 7.5v 20a switching power supply as described by John M. It is adjusted up to 8v, but once I get the system running, I will experiment to see if every thing will run at 7.5v ( I suspect it will). Since I couldn't find a ± 15v or ±16v switching power supply, I decided to go with a Power One dual 15v 3a linear supply found on eBay. The AC input is fused as are all of the DC voltages prior to connection to the 8 slot backplane. I also included a solderless breadboard in case I was to try some parallel I/O interfacing or serial I/O interfacing. Since the board is rear heavy, I mounted 2 handles on the board to make it easier to pickup & transport. I realize this is no great breakthrough or anything but I wanted to share what I was doing. Regards, Jeff Galinat -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
