Hi All, I have been slowly working on my Z-80 V2 board. I am taking my time, as the end is not the goal, rather the journey is the fun part. I solder each part in place after checking three times to make sure it is the right one, then I inspect the solder joint with a high power magnifying loupe to make sure it is up to standard. If not, it is fixed. As I assemble each component to the board, I check it off on the bill of materials list that I printed off. This way, I hope to minimize mistakes.
Thus, here is my questions... First, is C-3 really a 0.1 uf ceramic cap? It is next to three (the only three) electrolytic caps, and the mounting area for it is a circle with a polarization indicator. The second question is about the LEDs... D 1,3,4 and 5 are listed but not D 2,7 and 8. I just want to be sure that those are LEDs as well. (no assumptions here :-) Also, on the subject of LEDs, am I correct in that the flat side of the LED goes toward the little notch in the circles? The third and last question that I have concerns two rectangular boxes near U 9 and U 29 that have the number 220 inside of it. Is this a 220 Ohm resistor? There is no "R" number in the boxes. Thank you very much! This is really a neat project. When I was a kid, and the IMSAI machine came out, I did not have the means to get one. So I am now building one 40 years later as I type this on my Dell notebook right next to my work area where I am building this board. Couldn't ask for any more! :-) Best, Joe -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
