Hello, I did try swapping the PIOs around to no effect, but I don't have my system in a state where I can enter command/monitor mode just yet. I have a Cromemco Z80 (still working on N8VEM Z80 board), working N8VEM memory board and Harte Super I/O working with serial console, but no operating system.
Thanks much, Pete On Feb 12, 2014, at 10:09 AM, John Monahan <[email protected]> wrote: > Pete, the drive number is set by the onboard Z80. Go to the command/monitor > mode and see if you can output u11, bits PB0 & PB1. If not, bend up u11 > pins and retry. In this fails probably bad PIO. > John -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
