John, My plan was to decode and map the MDA registers into one "control cog" in addition to the memory mapped IO going into a "RAM cog". This cog could store the register information in hub RAM and then the cogs drawing the screen could check the registers in the horizontal blanking interval and do scrolling, etc.
Both the memory and registers would be at the same addresses as on a real MDA board with a 6845. I need to look at the Int 10h assembly code in the original IBM PC BIOS but I think we'd be able to use the original BIOS code unmodified. Andrew B On Saturday, July 12, 2014 5:17:36 PM UTC-7, monahanz wrote: > > Hi Andrew, > > FWIW, I have spent many hours on looking for the “holy grail” you > mentioned below. What appears to be a somewhat simple problem becomes a > can of worms when you get into it. I have written up some of this here:- > > http://s100computers.com/My%20System%20Pages/VGA%20Board/VGA%20Board.htm > > and here > > > http://s100computers.com/My%20System%20Pages/ISA%20to%20S100%20Bus/ISA%20To%20S-100%20Bus%20Board.htm > > > > That effort Andrew Lynch and I are still pursuing (now using GAL’s), but > still a few months away. > > > > Anyway the issue you have (if I’m understanding you correctly) is you > don’t have a 6854 video chip in the circuit. I assume then you will be > emulating the PC BIOS Int 10 calls with the Propeller. First you will > have to do it in Propeller assembly (spin is too slow) but even with that > some calls (like a screen scroll) may be too slow. Just plopping an ASCII > character pattern in the right RAM location won’t be understood bt the > Propeller the same way it is by a 6845 as I’m sure you know. > > > > > > John > > > > > > *From:* [email protected] <javascript:> [mailto: > [email protected] <javascript:>] *On Behalf Of *Andrew Bingham > *Sent:* Friday, July 11, 2014 7:48 PM > *To:* [email protected] <javascript:> > *Subject:* [N8VEM-S100:4525] PropMDA IBM MDA Compatible Graphics Concept > > > > All, > > > > I've been brainstorming about ways to get an IBM PC-compatible display > going with readily available parts. Either to use with the SBC-188 (or a > modified version thereof), or the S-100 MS-DOS Support Board + 8088 board. > > > > I think I've come up with a concept that would allow the Propeller to be > used in an IBM MDA-compatible configuration. > > > > This is not the "holy grail" of having a VGA or SVGA adapter but I think > it would be a good starting point as far as running a subset of MS-DOS > programs that manipulate the text buffer directly. > > > > Anyway let me know if it looks like this has any kind of merit. > > > > I have some more ideas in this direction involving a real dual port RAM > PLCC chip + the Propeller that might actually make CGA > all-points-accessible graphics possible as well but I am still doing some > calculations to see if the Propeller can handle it with "all cogs firing". > > > > Andrew B. > > -- > You received this message because you are subscribed to the Google Groups > "N8VEM-S100" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected] <javascript:>. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
