Probably because the code was not yet written Frank. If you are able to read both sides with the 0E & 0F commands then your hardware is probably OK.
Take a look at the source to check however John From: [email protected] [mailto:[email protected]] On Behalf Of Frank Schieschke Sent: Wednesday, July 16, 2014 12:49 AM To: [email protected] Subject: [N8VEM-S100:4609] Re: Get the ZFDC controller to format a disk... Hello John, i notice while testing, that the ZFDCDIAG program subroutines 11 & 12 (R/W tests) only uses one side of the disk. On the screen the side changed between A & B, but not on the hardware. The read tests 0E & 0F are working with two sides. Is there a reason for? Frank -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
