Hi Josh & all,
I realize that all the software & firmware is still in the
development stages but I figured that I would mention a few problem I am
having. I have done the xmodem transfer to memory & CP/M save as
described in Josh & Rich's previous responses. It has worked for a few
files such at STAT.COM but if I do a dir command after the save
completes sometimes the directory appears as gibberish until I reboot
the machine. After a reboot the directory usually appears as it should
including the new STAT.COM file which executes most of the time
(sometimes it just hangs the system). I have run memory tests using the
monitor on all the range of memory I can test without overlaying
anything and all appears to be good. Also I searched high & low through
all the CP/M archives I could find but was unable to find an CP/M xmodem
program that I could upload to the system to make transfers easier. Doe
anyone have a favorite CP/M xmodem program they could send to me?
jgalinat<at>optonline.net
Thank for any help you can provide.
Regards,
Jeff
On 9/2/2014 6:13 AM, Jeff Galinat wrote:
Hi Andrew,
That sounds like a good plan of attack. If I am successful & get a
typical CP/M disk built I will make sure to share it. Thank you!
Regards,
Jeff
On 9/2/2014 3:22 AM, Andrew Bingham wrote:
Since XMODEM was originally written on CP/M, I think you could get a
CP/M XMODEM program SAVEed and then run that from *inside* CP/M and
not have to drop back to the monitor, etc. for each file.
Andrew B
--
You received this message because you are subscribed to the Google Groups
"N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
