Hi All; Thank You, G. Beat for Your answer.. I didn't state it, but my Drive is an 8" 50 pin drive.. So, maybe from what You are saying it could be my Disk change.. option..
THANK YOU Marty On Friday, October 3, 2014 8:01:21 PM UTC-6, Marty Geist wrote: > > Hi All;' > When I try to boot CPM3 from my ZFDC Board, it states that the Drive is > not Ready.. > Yet, in Diagnostic mode after downloading ZfdcDiag, it works fine and I > could copy and format to it.. > So, I am thinking I might not have the In Use Jumpers on my Qume 242 Drive > set up correctly.. > Here is the options from the Manual for it: > > CUSTOMER STRAPPABLE OPTIONS > IN USE OPTIONS > Normally, the In Use LED indicator will be energized when DRIVE SELECT is > active. The door solenoid will be activated when DRIVE SELECT and READY are > active. The three options listed below will energize the In Use LED when > activated to a low level. > Option 1 > The option will energize the In Use LED when the DRIVE SELECT or IN USE > line > is active. > Installation (refer to the PCB Option Features illustration): > Plug pins D on the optional I/O pins. > Option 2 > This option will energize the In Use LED when the HEAD LOAD or IN USE line > is > active. > Installation (refer to the PCB Option Features illustration): > 1. Open trace Z on the programmable shunt with a small screwdriver. > 2. Plug pins D on the optional I/O pins. > 3. Plug pins Y on the optional I/O pins. > Option 3 > This option will energize the In Use LED only when the IN USE line is > active. > Installation (refer to the PCB Option Features Illustration): > 1. Open trace Z on the programmable shunt with a small screwdriver. > 2. Plug pins D on the optional I/O pins. > > So, which one is correct for use with the ZFDC Board, or Could it be > something else ?? > > THANK YOU Marty > > -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
