Jameco has a couple of them on page 118 of their catalogue. The pins do not fit the board holes however, You have to bend one pin along the back and then near the end bend it down to fit into the hole. Be careful the pins brake easily.
John From: [email protected] [mailto:[email protected]] On Behalf Of Frank Schieschke Sent: Sunday, October 26, 2014 5:44 AM To: [email protected] Subject: [N8VEM-S100:5450] Re: MSDOS Support Board V2 battery holder I have had the same problem. I drilled a additional hole and the 20.5mm holder sits in very well. Then removing some of the solder mask around the additional hole and solder it in. Frank -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
