I'm attempting to test and use an SD Systems Prom-100 S-100 EPROM burner card.
I found some source code apparently originally transcribed and converted to Macro asm by Andrew Lynch here: Note my manual has some listings but don't use macros. Hoping to eliminate transcribing. This source appears newer and maintained. http://www.retrotechnology.com/herbs_stuff/PROM08u.asm I obtained marco3.lib here: http://www.filewatcher.com/m/MACRO3.LIB.20170-0.html When I assemble with MAC I get the following. I>mac prom08u CP/M MACRO ASSEM 2.0 S ********************************************************* L LBCD OPR2 ;NUMBER OF BYTES REQUIRED 0746 02BH USE FACTOR END OF ASSEMBLY I> OPR2 is defined OPRS: DS 6 OPR1 EQU OPRS OPR2 EQU OPRS+2 OPR3 EQU OPRS+4 SPVAL EQU OPRS+100H Any ides on the proper syntax for the offending lines? I see two lines with **** both preceded by ';' I don't see any ************** lines that aren't commented. Does the L indicate a bad macro? LBCD OPR2 or ??? -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
