I remember going through similar issues many, many years ago when I was bringing up my first S-100 CPM 2.2 machine, and wishing beyond hope that I had a front panel so I could troubleshoot such issues. But even then an Altair or Imsai was way beyond my college-student means. I assume you don’t have a front panel? I wish you luck without it, but keep your ears to the list, as I have something coming along in the not too distant future (I hope!) that might be useful for you.
Bob Bell From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Friday, June 12, 2015 10:35 AM To: [email protected] Subject: [N8VEM-S100:7225] Re: Z80 CPU board setup issue Thanks for the help. I downloaded the HEX file from David and burned it to a 27C64. That seemed to program okay. Thanks. I also checked my jumpers against the scan posted by Gary. Thanks. The only difference that I found was the jumpers related to changing from the 27C64 to the 28C64 since these chips have different pin outs. Now when I power up the Z80 I get a hashtag, #, appearing on the screen of the console I/O. Not sure what that means but at least I got some response. I have been using this propeller board for some time now with Josh's 8080 CPU and it works fine. I checked the jumpers but I used the jumper configuration that is shown in the build steps on the website. So, not sure what to do next. Any ideas would be great. On Wednesday, June 10, 2015 at 10:41:45 PM UTC-4, [email protected] wrote: Hi everyone. I just finished building the Z80 board and I am having some problems, so I am hoping that some of you have some ideas. My system is the following: V2-S100 Z80 Master CPU board 4Meg static RAM board Prop I/O board I have the Z80 board jumpered as master. I also have a simple switch for reset. The RAM board is set for 1Meg only at 0000H. After power has been applied and reset issued the following conditions exist: On the Z80 board the 'BUS Master' LED (D8) turns on along with the 'LOW ROM' and 'ROM SEL' LED's On the RAM board the 'BS' and 'R0' LED's light up. Also the 8bit read LED and the 8bit write LED turn on. Unfortunately nothing happens on the screen connected to the prop I/O I have attached a picture. I tried to follow the table for the Z80 board jumpers and basically followed the examples. My main concern initially was the ROM monitor program. The only program available for downloading is version 5.02 which uses two 4K pages. I am using a uv erasable 27C64 instead of the eerom 28C64 that is shown on the S100COMPUTERS website. I compiled the program as described and generated the master.com file, but when I loaded this file onto my eprom burner the code did not match the listing! I set the transfer to the buffer at F000H. However, the HEX file looked okay, so I used that. Not sure that is right- I haven't burner roms for many years. So If anyone has any ideas or comments that would be great. I am up for any suggestions. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
