On Tue, Aug 24, 2004 at 10:45:22PM -0400, John R. Sosebee <[EMAIL PROTECTED]> wrote:
> > some flava's of the GSR will show/report this .. under show controller but > cisco says it's +_ 5 dbm .. > they say .. ' You want a router or a meter ? " > I have to agree .. would want not the expense of this added in. Cool, upon further discussion with hardware guys, most of this functionality is being built into the 3rd party optical components these days, so all the vendor has to do is augment the CLI to pass this data through. If the capability is there, why not use it? I must say it would be cool to graph dBm over months/years in Cricket, and see if you could spot fiber degradation. However, as you point out, it is important for vendors to document the accuracy of the readings in their spec sheets. +/-5 dBm sounds a bit lame. As I understand, these components split off about 2% of the light to take the optical power readings. Don't know if any of them can measure reflection to get distance as well? -Lane > > > POS3/0 > SECTION > LOF = 0 LOS = 0 BIP(B1) = 0 > LINE > AIS = 0 RDI = 0 FEBE = 0 BIP(B2) = 0 > PATH > AIS = 5 RDI = 6 FEBE = 387 BIP(B3) = 6389 > LOP = 5 NEWPTR = 0 PSE = 0 NSE = 0 > > Framing: SONET > APS > > Optical Power Monitoring > Rx optical power in mWs and dBms > Port 0 = 0.02 mW, - 15.738 dBm > > Tx laser diode forward bias current I(F) in milliamps > Port 0 = 18.009 mA > > > Clock source: line > >
