On 05/12/2010, at 2:29 PM, Mark Radabaugh wrote: > On 12/4/10 10:52 PM, Ben Jencks wrote: >> On Sat, Dec 4, 2010 at 22:40, Mark Radabaugh<m...@amplex.net> wrote: >>> Probably a case of something being blindingly obvious but... >>> >>> I have seen plenty of information on IPv6 from a internal network >>> standpoint. I have seen very little with respect to how a ISP is supposed >>> to handle routing to residential consumer networks. I have seen suggestions >>> of running RIPng. The thought of letting Belkin routers (if you can call >>> them that) into the routing table scares me no end. >>> >>> Is this way easier than I think it is? Did somebody already write the book >>> that I can't find? >> DHCPv6-PD (prefix delegation) with the relay installing static routes >> is probably the most straightforward way. Letting home CPE participate >> in routing does indeed seem like bad idea; I haven't heard that >> seriously suggested before. >> >> -Ben > I had found the documentation on DHCPv6-PD but didn't see the mechanism > for getting the assigned prefixes into the router.
RADIUS. When your session comes up you get, in our trial (http://ipv6.internode.on.net) a /64 assigned to your PPP interface. You can choose to send an RA and assigned your router an IP in this or not. Otherwise your router sends a DHCPv6 PD request to our BRAS. Our BRAS knows who you are and does a radius request. Our RADIUS server sends back either a pool name or a static /60 (for the trial) which then gets routed to your interface. You then assign internally as required. MMC
