Hi there, I have a Cisco 7606 with this module on it: WS-SUP32-GE-3B
and I am using its own 8 port like this: 2 Port Layer two ether-channel uplink to my 4900 Cisco Switch and 1 Layer two uplink to Internet, and near 10 tunnel to my customers for internet exchange with BGP peering + some policy map for shaping tunnel interfaces. My ether-channel traffic on 600Mbps (each port 300Mbps) I get 90% cpu load and ping time problem on my router, what is the problem?? And when I run: show processs cpu sorted I get a "Unknown" process eat the cpu process... I try lots of IOS version but it does not make difference. My IOS version is: c7600s3223-adventerprisek9-mz.150-1.S1.bin and some general configuration: no ip source-route > ! > ip cef load-sharing algorithm original > no ip domain lookup > ! > ! > ! > ! > mls ip cef load-sharing full > no mls flow ip > no mls flow ipv6 > mls qos > mls cef error action reset > multilink bundle-name authenticated > ! > spanning-tree mode pvst > spanning-tree extend system-id > system flowcontrol bus auto > diagnostic bootup level minimal > port-channel load-balance src-ip > username admin secret 5 $1$g6WX$LaQbPyD3qIaHsF5qTqt8g0 > ! > redundancy > main-cpu > auto-sync running-config > mode sso > ! > ! > ! > ! > vlan internal allocation policy ascending > vlan access-log ratelimit 2000 Thanks -- Regards, Shahab Vahabzadeh, Network Engineer and System Administrator Cell Phone: +1 (415) 871 0742 PGP Key Fingerprint = 8E34 B335 D702 0CA7 5A81 C2EE 76A2 46C2 5367 BF90
