The nylon shims and rollers on the back of my tiller where the up
and down lines of the rudder run are weathered and could use
replacement.I,m just not sure how to remove them as there is no
obvious through bolt or pin.I don,t want to start pulling the rudder
casing apart without an understanding of how it is put together.The
nylon shims are brittle and I would hate a failure at an inopportune
time.Thanks,Harold F27 279.
| Yahoo! Groups Sponsor | |
|
|
Yahoo! Groups Links
- To visit your group on the web, go to:
http://groups.yahoo.com/group/F-Boats/
- To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
