On Aug 30, 6:51 pm, "threeneurons" <[email protected]> wrote:

> The switcher Hans uses is the MKI version of the MC34063. Its of limited use. 
> Here's a schematic of my MK1.5 Version:
>
> http://snipurl.com/10ze78
>
> There are several improvements. (1) C1 in the feedback path adds stability to 
> the circuit. Its gets rid of what you call noise.
>
> The FET drive is improved, so it now both actively pulls Up, and Down, the 
> signal applied to the power FETs gate. The old version only pulls up, and has 
> a passive pull down (a 330 ohm resistor). This greatly improves efficiency. 
> The old circuit could only deliver ~10mA. The new circuit, is the one I sell 
> on eBay, and can easily deliver 45mA.
>

WOW, i tried making a PCB with that schematic, trying to lay it out as
best as i could, and it works brilliantly!

I used all the parts on the list but substituted the MPSA55 with the
venerable BC557, as i couldnt find any MPSA55 in my junk box :-)

I used a coil from an old smps board in a printer - i just have the
problem of the coil singing... Maybe some transformer varnish can
quiet it down ?

At the moment i have only tested the supply with 3 IN8-2 tubes on my
multimeter, and it works fine.

// Per.

-- 
You received this message because you are subscribed to the Google Groups 
"neonixie-l" group.
To post to this group, send an email to [email protected].
To unsubscribe from this group, send email to 
[email protected].
For more options, visit this group at 
http://groups.google.com/group/neonixie-l?hl=en-GB.

Reply via email to