http://www.elmelectronics.com/ebench.html#Oscillators
| Larry <[email protected]> wrote: | I recently completed a Kabtronics Nixie clock that uses line | frequency. Now I'm going to have to add a 60Hz generator to it. | Thanks for the link. If you can change the input source (3.58MHz xtal), or tweak it, you might just want to leave things alone. There are 525,960 minutes in a year, on average. 525,600 for a normal year, and 527,040 for a leap year. Being off 20 minutes in a year works out to ~38ppm (East Coast). 8 minutes comes out to 15ppm (West Coast). A typical crystal has 30 to 50 ppm accuracy, or between 15 to 26 minutes off, in a year. You'll get no improvement with a common crystal. You might just as well just stick with the line sync, and just occasionally hit that minute button, to correct the time. That module won't help you unless you swap out that xtal, and tie a TCXO to the clock input. Of course, you'll need to match the frequency, or write your own uC code. A TCXO has an initial accuracy in the 1ppm to 2.5ppm territory. Even when extra errors, such as aging coming into play, you're still a lot better off than using a cheap xtal. I actually use to sell a coded uC (a tiny12 in fact) on eBay, that outputed 50Hz, 60Hz, and 1Hz. Sold it for $5 each. Maybe I should just post the source code, to screw with that guy. Code is pretty trivial. -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To post to this group, send an email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/neonixie-l?hl=en-GB.
