If it's "close", I think it would still be worth getting one. Don't need access to the selector block, and don't mind drilling a hole or two, or more in the back. If the unit will physically fit and look fine from the front, then I will still want one. Michail
In a message dated 9/1/2011 9:00:24 A.M. Pacific Daylight Time, [email protected] writes: Mike, the PCB dimensions remain the same. As do the original mounting holes and tube locations when compared to Pete's original FW4. Where a big problem arises is that the components are now on the bottom of the board, with only the tubes on top, and neither the connector or switch locations line up with the original layout. The new GPS FLW enclosure is not compatible. Regards, Jeff On Aug 31, 7:13 pm, [email protected] wrote: > Is this the same SIZE as the original Pete Hand FLW? > > If so, I would like to at least get one enclosure for the unit I have > already. > > Michail > > In a message dated 8/30/2011 11:01:24 A.M. Pacific Daylight Time, > > [email protected] writes: > > The owner can > design their own enclosure, or purchase the pre-cut acrylic version > for $25. when ready. -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To post to this group, send an email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/neonixie-l?hl=en-GB. -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To post to this group, send an email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/neonixie-l?hl=en-GB.
