Is the chip you're trying to program already programmed ?
I have found that sometimes forcing a seperate Erase cycle can make a
difference.
Are they in the same circuit/programming socket ? If not, is the
negative/earth at the same potential as your PC/programmer ?

I once had a similar problem with a pic which wouldn't program, if I
recall it was to do with the code which ran immediately after powerup.
I think the trick with it was to run it off the Pickit's 5v supply and
let the pickit software control the power.

I have also read that pulling pin 10 low via a 3m3 resistor is a good
idea.
http://www.microchip.com/forums/m497788-print.aspx


I got a pickit 3 to replace a pickit 2 and have to say I'm
disappointed.
About the only benefit is the debugger. If you don't need a debugger a
pickit 2 with the logic analyser and data terminal software is a much
better prospect IMHO (for the things I need it for at least)

Chris
.


-- 
You received this message because you are subscribed to the Google Groups 
"neonixie-l" group.
To post to this group, send an email to [email protected].
To unsubscribe from this group, send email to 
[email protected].
For more options, visit this group at 
http://groups.google.com/group/neonixie-l?hl=en-GB.

Reply via email to