Hi Gang,

Roy Soyland can not answer, he told me has some problems with his account here.
We are now working on it getting his account working.
But he sent me his answer and I'm happy I can forward it to you. 
He also sent an interesting picture!
See attached!
THANKS RON! :-)


Here is what Ron wrote:

"On the mercury infusion tube, I have no experience with it at all. The tube 
has a piece of asbestos in it that is saturated with mercury. The heater wire 
heats the tube causing the mercury to evaporate into mercury vapor.  I think 
the infusion tube is placed in the evacuation stem (or a side tube on the stem) 
of the nixie so it is not included inside the nixie when it is sealed off. I 
would guess the end of the tube is first cracked open to expose the inside 
element. Then after the vacuum has been completely finished the infusion tube 
would be heated with the wire heater to increase the vapor pressure of the 
mercury to whatever degree is desired. It doesn't take much temperature. The 
attached photo shows an early type vacuum tube that used an infusor to supply 
mercury vapor to the tube during operation.
 I can see that some sort of mercury infuser would be necessary outside of the 
nixie, since mercury has a vapor pressure at room temperature of about 10 -4 
torr. Thus, if the mercury was included in the nixie during making it, the 
vacuum processing would pull it all out. It has to be put in after the tube has 
been outgassed.
  I would think a side tube with a stopcock would be satisfactory and would 
work with many nixies. I don't like using mercury in my system since it tends 
to collect in the diffusion pump oil and limit the lower end vacuum attainable. 
I'm quite sure the amount of mercury in a nixie tube is so small that you can't 
see it. I've seen some posts somewhere where someone was afraid of pulling 
mercury out of the nixie into their vacuum pump and was making an elaborate 
trap to catch the mercury drops! Seems a bit far fetched to me. I have never 
seen "drops of mercury" inside a nixie before. 

ron"

Have a nice one
Dieter



From: Dalibor Farný 
To: [email protected] 
Sent: Sunday, May 27, 2012 10:27 PM
Subject: Re: [neonixie-l] ZM1042 (Valvo) Nixie tube updated


Thanks for reply, I hope Ron will answer.. So the pill is closed on both ends 
before inserting in vacuum? I cant imagine the process of sealing the pill full 
of mercury or evaporating from closed pill..

But thanks for that info,

Dalibor


2012/5/27 Dieter Waechter <[email protected]>

Hi!
If I remeber well, the mercury was soaked up by a light vacuum into the giver 
pill.
Then sealed on both ends
Then the heater wire was wrapped around it.
Spot welded onto the tube construction.
Then it was heated up to vaporize the mercury.
But Ron Soyland might know more about it.
Hope he is listening here?
A big hand on him from me on this position.
;-)
Dieter

-- 
You received this message because you are subscribed to the Google Groups 
"neonixie-l" group.
To post to this group, send an email to [email protected].
To unsubscribe from this group, send email to 
[email protected].
For more options, visit this group at 
http://groups.google.com/group/neonixie-l?hl=en-GB.

<<attachment: infusor.jpg>>

Reply via email to