David, would you consider adding a socket for the nrf24L01+? Even if you don't implement any functionality with your initial software release, lots of options such as remote control and who knows what else, become available. And all it takes is 3.3v and connections to the SPI bus.
On Friday, January 15, 2016 at 12:58:11 AM UTC-5, nixiebunny wrote: > > I have been doing a lot of component placement work on the new scope > clock board. Tetris! This is what it looks like. The six square controls > with equilateral triangle dots are the oscilloscope knobs, and the > function encoder is at bottom center. The other square pots are trimmers > accessible through the front panel. > > The HV power supply is at upper left, deflection at upper right, V power > lower left, computer at lower right. A big USB-B connector is behind the > lower right corner. RTC battery is at bottom. > > The thru-hole parts (other than controls) are rear mounted, with all SMT > parts on the front. There will be 5/16" standoffs in the six outer holes > to mount the board to the front panel. > > This is a work in progress. > > -- > David Forbes, Tucson AZ > -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/5ee3962f-55c0-40a9-b961-292d555fb485%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
