> That would be great! Yes i would like to include to include power for the > leds, mounts sized for the nocrotec lighted sockets and a connection for the > 20 pin ribbon cable from the main board.
Note that the 20 pin cable doesn't include LED power. How do you want to power the LEDs? There is one unused pin, but you'd need two. Do you want the ribbon cable plugged on the tube side or the other side of the board? Do you want the colons like in that diagram? Do you have a pinout for your colon stacks? Do you want the anode resistors on the board? Do you want the LED current limiting resistors on the board? Do you want the colon current limiting resistors on the board? Is the 20 pin connector to be an ordinary 2x10 pin Berg connector (0.1" spacing)? How far apart do you want your IN-8 tubes? The IN-8 socket data sheet recommends 23mm. Do you want them spaced differently around the colons? Do you want mounting holes? If so, how many and where? Do you want the board to have any particular dimensions? > What would you charge for that? I'm willing to do it for free, I kind of enjoy laying out circuit boards. - John -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/52328193-549A-4C36-9319-5BE7E5ADFE32%40mac.com. For more options, visit https://groups.google.com/d/optout.
