Thanks Three! I think I was worried about the HV being just one chip
away from the MCU. I'm not an EE and have never even played one on TV.
I'll go direct, it's easier anyway.
Jonathan
On 1/25/2018 12:59 AM, 'threeneurons' via neonixie-l wrote:
I'd get rid of the 1Ks, and go directly. They are powered, from the
same 5V supply ? Unterminated TTL inputs float to ~1.6V, look like an
"iffy" logic-1. To drag them down to solid logic-0 (0.8V min) requires
a "sink" current of 1.6mA for old standard TTL. A 1K is too big.
Unused TTL inputs are almost always terminated high, as the "source"
current to a good logic-1 (>2.0V) is much smaller than the sink
current. To terminate original TTL low, would require a resistor ~220
ohms.
On Wednesday, January 24, 2018 at 2:26:19 PM UTC-8, Jonathan wrote:
Hi All,
I am finally getting around to soldering up a pixie tube thermometer
that I bread boarded quite a while back. It uses a PIC and two
SN7414N's. On the bread board I have 1k resistors in series from the
output pins of the PIC to the input pins of the SN74141Ns. Usually
I am
using shift registers but with a two digit thermometer I am coming
directly off of the PIC pins. I can't seem to remember why I put the
series resistors in there. Are they required?
Forgetfully yours,
Jonathan
--
You received this message because you are subscribed to the Google
Groups "neonixie-l" group.
To unsubscribe from this group and stop receiving emails from it, send
an email to neonixie-l+unsubscr...@googlegroups.com
<mailto:neonixie-l+unsubscr...@googlegroups.com>.
To post to this group, send email to neonixie-l@googlegroups.com
<mailto:neonixie-l@googlegroups.com>.
To view this discussion on the web, visit
https://groups.google.com/d/msgid/neonixie-l/8e4644c2-7fe6-4c82-84a1-ec2c990d3456%40googlegroups.com
<https://groups.google.com/d/msgid/neonixie-l/8e4644c2-7fe6-4c82-84a1-ec2c990d3456%40googlegroups.com?utm_medium=email&utm_source=footer>.
For more options, visit https://groups.google.com/d/optout.
--
You received this message because you are subscribed to the Google Groups
"neonixie-l" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to neonixie-l+unsubscr...@googlegroups.com.
To post to this group, send an email to neonixie-l@googlegroups.com.
To view this discussion on the web, visit
https://groups.google.com/d/msgid/neonixie-l/3687e585-8b16-fa19-e743-d17a74a7c5b3%40madlabs.info.
For more options, visit https://groups.google.com/d/optout.
