I just received some ILC1-1/8 VFD's (large-ish 7 segment Soviet era, approx 100mm tall) and did some basic testing.
I was very surprised to see a large current on the grid, on the order of 30-40mA, whereas the segment current was around 5mA when glowing nicely. I havn't dabbled with vacuum tubes since my high school electronics class in the 1970's, but I always remember the grid current was very small (of course....if it wasn't small the tube isn't doing it's job as an amplifier....) Anyways, for any of you VFD folks out there who have experimented with VFD tubes that have a grid, were you seeing significant current ? I havn't found the official datasheet, but the info I gathered does state there is a grid current in the 100mA range at higher voltage (around +35V). My own experimenting found that I get good illumination at lower grid voltages (which means lower grid current) around +18V . I thought that perhaps the grid + filament is operating like a rectifier tube, where the grid is acting as an anode. Normally, the grid is biased negatively to shut-down the tube-current; with this particular VFD the grid is positive. I have confirmed that positive grid bias is needed in order to get the tube segments to light-up. I also confirmed that around +12V of grid voltage, the current starts to ramp-up. I'm reluctant to drive the segments at a higher voltage and leave the grid at a low-enough bias such that it's current is zero; in the end it's probably a zero-sum for reducing power dissipation. -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/17e6341a-2e15-41f9-92c0-6067c0c9af1f%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
