A whole bunch of IN-28s. The current won’t be constant, and I don’t want the voltage to fluctuate, so time for plan B it seems. Whatever that might be.
Thanks for the insight, is that on that datasheet somewhere? > On Feb 20, 2020, at 6:48 PM, gregebert <[email protected]> wrote: > > > Essentially, yes. But be aware of the open-circuit output voltage; the supply > will attempt to pump-out the amount of requested current, and in order to do > so, it will increase it's output voltage until the desired current is > obtained. > Just make sure that *you* are not the load. For example, if you set the > current to 150mA, and touch the terminals, you will probably be killed. I'm > not joking. The 1400mA supply will crank out as much as 420V, and 100-200mA > is fatal. > > I suspect that when the supply is energized, it will rapidly increase the > output voltage from 0 volts, up to the maximum no-load output voltage (420V), > until the measured current reaches what you set it to. If the load's > resistance decreases as the current increases, the output voltage will also > decrease; this is typical behavior of a gas discharge as it ionizes. > > What are you driving from the supply ? > -- > You received this message because you are subscribed to a topic in the Google > Groups "neonixie-l" group. > To unsubscribe from this topic, visit > https://groups.google.com/d/topic/neonixie-l/imrmZ6PC1vw/unsubscribe. > To unsubscribe from this group and all its topics, send an email to > [email protected]. > To view this discussion on the web, visit > https://groups.google.com/d/msgid/neonixie-l/697ad42d-569c-486c-82d1-996b051edfb9%40googlegroups.com. -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/A106DFFE-9773-4B62-9672-105BE9CBDFFE%40gmail.com.
