Ah, good question, it is set up for Z568 - that could be an issue! ... though if there was sufficient interest I would make one for Millclock pinout. - Richard
On Wednesday, 9 February 2022 at 03:32:02 UTC [email protected] wrote: > Is the board setup for z568m or the millclock in house pinout? > > On Tue, Feb 8, 2022, 10:27 PM Richard Scales <[email protected]> > wrote: > >> I don't have their clock - but i do have a board that drives 6 of their >> tubes as a wifi connected, ntp synced clock with motion detect option, web >> config, automatic time zone and DST , tube underlighting - just in case >> things go really bad.... >> Actually - I even have some boards for a two board version which take >> their colon towers too! >> - Richard >> >> >> On Wednesday, 9 February 2022 at 01:26:50 UTC [email protected] wrote: >> >>> Love my clock but there seems to be some bugs in the firmware. If any of >>> you have one of these I'd love discuss the clock with you and see if some >>> of my experiences are in line with yours. >> >> -- >> You received this message because you are subscribed to a topic in the >> Google Groups "neonixie-l" group. >> To unsubscribe from this topic, visit >> https://groups.google.com/d/topic/neonixie-l/xlBX84G1E4Q/unsubscribe. >> To unsubscribe from this group and all its topics, send an email to >> [email protected]. >> To view this discussion on the web, visit >> https://groups.google.com/d/msgid/neonixie-l/4399a235-252f-415d-bcbc-d0c64a253ba5n%40googlegroups.com >> >> <https://groups.google.com/d/msgid/neonixie-l/4399a235-252f-415d-bcbc-d0c64a253ba5n%40googlegroups.com?utm_medium=email&utm_source=footer> >> . >> > -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/02d17052-b94c-47bf-8182-84bd826ae24en%40googlegroups.com.
