Thanks a bunch, Dan!
Tom
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
Behalf Of Dan Gomez
Sent: Monday, November 17, 2008 2:49 PM
To: [email protected]
Subject: RE: NEOTEK: Balancing A Series 1
The Transisters came from different search. NEOTEK often bad about
trans. types on schemos!!
Dan
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
Behalf Of Tom Gorichanaz
Sent: Monday, November 17, 2008 10:23 AM
To: [email protected]
Subject: RE: NEOTEK: Balancing A Series 1
Importance: High
Hello,
Yes I would. I've been looking around and found a few ideas but yours
sounds like a good way to go.
Thanks,
Tom
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] Behalf Of Dan Gomez
Sent: Monday, November 17, 2008 12:06 PM
To: [email protected]
Subject: RE: NEOTEK: Balancing A Series 1
I have the schemo for the transister based balancing ckt from Neotek
that was an option at the time. Very simple and cheap trans. in the design.
Would you like a copy?
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] Behalf Of Tom Gorichanaz
Sent: Monday, November 17, 2008 6:28 AM
To: [email protected]
Subject: NEOTEK: Balancing A Series 1
Importance: High
Hello,
I know this subject has come up before but I need a refresher. I
have a Series 1 that uses card edge connecters and need to address the
direct outs and line ins as well as the master outs. What are my options to
convert these to balanced?
Thanks,
Tom
