The folks at group DIY have a PCB built for balancing their SSL9K pre,
since it runs on +-18 as well it would probably fit in a Neotek
chassis perfectly. I think it employs line receivers as well, but you
could leave the input section out.
http://www.prodigy-pro.com/diy/index.php?topic=10776.0
Cheers,
LS
On Nov 28, 2008, at 8:26 AM, eliya gwetta wrote:
Thanks Ray!
On Fri, Nov 28, 2008 at 6:07 PM, rooster <[EMAIL PROTECTED]> wrote:
Hey
I have all series 1 schematics/block diagrams around here somewhere
i'll email it to you as soon as i locate it
ray
On Nov 28, 2008, at 10:39 AM, eliya gwetta wrote:
Hello everybody, I'm new here so, umm, hello!
There's no archive to look in so I figured I'll make a post. I'm
looking for a schematic/block diagram for Neotek Series 1 input
channel.
I tried searching the net, but found none, I'll be glad if any of
you can point me to where I can find the schematics. I emailed Sytek
but they didn't get back to me yet.
Thanks,
eliya
------
You can unsubscribe at anytime by sending an email to mailto:[EMAIL PROTECTED]
with "unsubscribe neotek" in the message body. If you have any
difficulties, or questions --please send an email to [EMAIL PROTECTED]
.
The Neotek list is lovingly hosted by Catapult Web Development.
Remember that any message or reply sent to the list will be
automatically forwarded to all subscribers.
Vive Le Neotek !
Thanks.
