Pulling all of the input strips is a BIG job, this being a 58 input
console. I would recommend pulling the ribbons from the motherboard 1st.
Then check the solo functions in the master section (like one of the Fx
returns). If the fault persists, then it is definitely confined to the
master section.
best,
Ike
Monte McGuire wrote:
On Jul 10, 2009, at 10:19 AM, Matt Syson wrote:
Hi
I would suspect that the left mix bus is shorted to ground or that a
channel is 'contributing' to it all the time which,without the DC bus
being engaged you won't hear in the monitors until you solo something
else.The FETs are used in a 'switching' mode rather than in a linear
amplifier fashion so I would not really be looking at these until
other things were checked.
I was at a loss to figure this out initially, but Matt's analysis
makes a ton of sense. To elaborate, if something severely reduced the
summing bus impedance, the noise gain of the summing amp would
increase drastically, causing lots and lots of hiss, yet the
transmission gain of any channel might not be affected.
I'd look for some sort of "soft" short, something that would
drastically reduce the summing bus impedance, but not completely short
out the summing bus. Maybe there's a whisker of stranded copper that's
sorta shorting the bus, or possibly some switching FET that is somehow
clobbering the bus, but not completely. Many switching FETs have
channel resistances of around 20-70 ohms when fully on, and this would
be about right - enough to make the summing amp run at a really high
noise gain, but not enough to clobber the signal currents sent from
the channels.
Best of luck tracking this down! One possible procedure would be to
pull all but one of the input strips and see what happens. If that
"fixed" it, cycle each strip in individually until you find the
culprit. (BTW, if it's not obvious, you need to power the console down
before you pull or add a module, then power it up to see what the
console does after you've reconfigured it ;-)
If the problem remains with most of the modules pulled, pull every
module that sums to the 2-mix bus (e.g. all inputs, effect returns,
etc.) and see what happens. If it's still noisy, then some sort of
connection in the frame is messed up and you can look there, and avoid
messing with the modules.
Regards,
Monte McGuire
[email protected]
------
View the list online at:
http://www.mail-archive.com/[email protected]
You can unsubscribe at anytime by sending an email to
mailto:[email protected] with "unsubscribe neotek" in the
message body. If you have any difficulties, or questions --please send
an email to mailto:[email protected].
The Neotek list is lovingly hosted by Catapult Web. Remember that any
message or reply sent to the list will be automatically forwarded to
all subscribers.
Vive Le Neotek!
Thanks.
--
Ike Zimbel
Zimbel Audio Productions Ltd.
Toronto
416-720-0887
"Studio House Calls" - Repairs and upgrades to analog audio equipment including:
Amek, Allen & Heath, Neve, Neotek, MCI, Soundcraft and more.
------
View the list online at: http://www.mail-archive.com/[email protected]
You can unsubscribe at anytime by sending an email to mailto:[email protected] with
"unsubscribe neotek" in the message body. If you have any difficulties, or
questions --please send an email to mailto:[email protected].
The Neotek list is lovingly hosted by Catapult Web. Remember that any message
or reply sent to the list will be automatically forwarded to all subscribers.
Vive Le Neotek!
Thanks.
