On Thu, Jun 10, 2004 at 11:59:22PM +0900, [EMAIL PROTECTED] wrote:
> Hi,
>
> I'm having a problem with running Nessus via an ipsec tunnel
> which is I can't do any other way. The problem is that the ipsec tunnel
> interface ipsec0 (virtual) has the same ipaddress and the same mac
> address as the real interface (eth0). Nessus seems to want to use ipsec0
> automatically which nothing will pass through it as eth0 has to be used.
> Nessus unlike nmap does not allow interface specification only ip
> address specification. Is there anyway I can do this? Maybe hard coding
> eth0 to the code and recompile? I would very much appreciate any ideas
> on this as I have tried searching the Internet and reading the docs but
> couldn't find anything. The ipsec tunnel software being used is
> freeswan.
By default, nessusd lets the operating system select the relevant
interface, so you should tweak your routing table so that the system
actually uses eth0 for its normal traffic.
-- Renaud
_______________________________________________
Nessus mailing list
[EMAIL PROTECTED]
http://mail.nessus.org/mailman/listinfo/nessus
