From: Niels Baggesen <[EMAIL PROTECTED]> Subject: Re: IPv6 Date: Fri, 2 Jul 2004 00:43:57 +0200 Message-ID: <[EMAIL PROTECTED]>
nba> On Thu, Jul 01, 2004 at 05:20:50PM -0500, [EMAIL PROTECTED] wrote: nba> > Isn't ::1 for localhost? nba> nba> Yes nba> nba> > That is a good place to start, but ultimately I will need to use a full IPv6 nba> > address for a remote SNMP agent. nba> > nba> > Would that be similar, in that you just replace ::1 with the full IPv6 nba> > address? nba> nba> Yes, or a hostname that resolves to an IPv6 address It's necessary to specify transport protocol for IPv6 transport, such as: > snmpget udp6:[::1] sysDescr.0 Please read AGENT SPECIFICATION in snmpcmd(1). Perhaps it is repuired to configure snmpd.conf for IPv6. The simple way is to add the following line in snmpd.conf: rocommunity6 COMMUNITY Regards, Katsuhisa ABE ------------------------------------------------------- This SF.Net email sponsored by Black Hat Briefings & Training. Attend Black Hat Briefings & Training, Las Vegas July 24-29 - digital self defense, top technical experts, no vendor pitches, unmatched networking opportunities. Visit www.blackhat.com _______________________________________________ Net-snmp-coders mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/net-snmp-coders
