Hi, I am a novice in net-snmp. I have a problem in a table with the following attributes: ifIndex: foreign key (ifTable) MacAddress: primary key. other attributes... I have generated the source code with mib2c command in MFD mode. I have tryed to put the table data in a two dimensional array in the table module.
If I want to view the following table with the table or walk command (I use MIB browser graphical tool), everything works fine: ifIndex | MacAddress | Attr1 | ... other attributes ... 1 000000 1 ........... 2 000001 2 ........... 3 000000 3 ........... 4 000001 4 ........... 5 000000 5 ........... 6 000001 6 ........... If the table is, instead, this: ifIndex | MacAddress | Attr1 | ... other attributes ... 1 000000 1 ........... 1 000001 2 ........... 2 000000 3 ........... 2 000001 4 ........... 3 000000 5 ........... 3 000001 6 ........... and I use the walk command, I get a never ending cycle with the following data: ifIndex | MacAddress | Attr1 | ... other attributes ... 1 000000 1 1 000001 2 1 000001 2 1 000001 2 1 000001 2 ...... If I use the table command, no data are shown and I get anew a never ending cycle. It seems that the correct behaviour depends on the data order in ifIndex. Have you any suggestions ? Thanks ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Net-snmp-coders mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/net-snmp-coders
