Simon,
Can you try with global addresses? I wouldn't be horribly surprised if
scope zones were not supported properly. (Global v6 addresses have worked
for me in net-snmp for years.)
Bill
On Mon, Jan 15, 2018 at 2:37 PM, Simon Chamlian <simon.chaml...@mpbc.ca>
wrote:
> Hi,
>
> Just recompiled the agent by enabling IPv6 ( --enable-ipv6).
>
> The agent is working fine but don't seem to be able to use IPv6.
>
> Example:
>
> # snmpget -v 3 -u Admin -a MD5 -A Admin-00 -l authNoPriv 172.27.42.199
> MPBC-1RU-MIB::mpbc1RUNEID.0 -Oqv
> "TestNew"
>
> works fine.
>
>
> In Ipv6:
>
> # snmpget -v 3 -u Admin -a MD5 -A Admin-00 -l authNoPriv
> udp6:'[fe80::6eff:beff:fe02:d0%eth0]':161 MPBC-1RU-MIB::mpbc1RUNEID.0 -Oqv
> snmpget: Timeout
>
> I also tried without the port
> # snmpget -v 3 -u Admin -a MD5 -A Admin-00 -l authNoPriv
> udp6:'[fe80::6eff:beff:fe02:d0%eth0]' MPBC-1RU-MIB::mpbc1RUNEID.0 -Oqv
> snmpget: Timeout
>
>
> Gives me timeout. What am I doing wrong? Do I need any special
> instructions in snmpd.conf file?
>
> Note that when I launch the agent, I get the following error message in
> the log:
> Error opening specified endpoint ""
> Server Exiting with code 1
>
> But the agent works fine with IPv4.
>
> Thanks,
> S
>
>
> ------------------------------------------------------------
> ------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> _______________________________________________
> Net-snmp-coders mailing list
> Net-snmp-coders@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/net-snmp-coders
>
>
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Net-snmp-coders mailing list
Net-snmp-coders@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/net-snmp-coders
