I was hoping for
some help on this one. The release notes says this works in this release
but the rpm I pulled down to work with my fc2 boxes does not have this
available. Although I see it in the MIB I cannot do a snmpwalk of the table nor can I do a get of the different oids. Is there a workaround to
this for this release or do I have to upgrade to a newer release in order for
this to work?
Regards,
Javier F. Torres
Sr. Network Engineer
Instinet / Inet ATS
*****************************************************************
<<
In compliance with applicable rules and regulations, Instinet
reviews and archives incoming and outgoing email communications,
copies of which may be produced at the request of regulators.
This message is intended only for the personal and confidential
use of the recipients named above. If the reader of this email
is not the intended recipient, you have received this email in
error and any review, dissemination, distribution or copying is
strictly prohibited. If you have received this email in error,
please notify the sender immediately by return email and
permanently delete the copy you received.
Instinet accepts no liability for any content contained in the
email, or any errors or omissions arising as a result of email
transmission. Any opinions contained in this email constitute
the sender's best judgment at this time and are subject to change
without notice. Instinet does not make recommendations of a
particular security and the information contained in this email
should not be considered as a recommendation, an offer or a
solicitation of an offer to buy and sell securities.
*****************************************************************
