On 29 July 2012 07:40, Naama Bar Menachem <naama.barmenac...@novelsat.com> wrote: > - I am using snmpB browser, and I tried both "walk" command on the tree > as well as "get> select instance" and "set> select instance" commands in > which I select an instance from a list (that was presented properly) > All these commands are resulted in timeout error.
Is this command issued on the same system as the agent is running on, or a remote system? Can you see anything else from that agent? (e.g. walking the 'system' tree) > conf file is attached. The most obvious problem with this config file is that you are mixing two different styles of access control. Please use EITHER r[ow]community OR com2sec/group/access But do not try to mix the two. I'd suggest that you delete the whole section starting "map an SNMPv1 or SNMPv2c community string..." up to "group privateGroup..." plus the two lines "access publicGroup...." "access privateGroup...." [I'd also strongly suggest that you use a different write community string other than "private" - if you support community-based SET requests at all!] Dave ------------------------------------------------------------------------------ Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Net-snmp-users mailing list Net-snmp-users@lists.sourceforge.net Please see the following page to unsubscribe or change other options: https://lists.sourceforge.net/lists/listinfo/net-snmp-users
